Uprights, hole spacing, and what catches the bar · review
PASYOU Squat Rack SR30 review
A heavy stand with a 5 × 5 cm section and a published 29.9 kg mass — and a listing whose title says 800 kg while its detail says the J-hooks take 200 kg. Both figures are reported here.
The bottom line The heaviest and thickest stand here, and the one whose own listing disagrees with itself. Five by five centimetres of steel at 29.9 kg is a real specification and fourteen J-hook positions is a fine ladder — but a title claiming 800 kg beside a detail stating 200 kg on the hooks is a contradiction the maker has to resolve, not the reader. Both figures are on this page for that reason.
What the maker publishes
Section 5 × 5 cm thickened steel plate
Stand mass 29.9 kg, described as the heaviest deep squat rack on the
market
14 J-hook positions, 7 bumper positions
Highest J-hook position 137.5 cm
J-hooks stated to carry up to 200 kg
4 bumpers, two on each side
2 plate storage posts at 50 mm
4 non-slip pads; damping screws stated not to loosen
One-year warranty; the maker states all measurements are actual results
The contradiction, reported
The title says up to 800 kg. The specification says the J-hooks carry up
to 200 kg.
Those are not obviously the same claim about the same part, and the listing
does not reconcile them. This site does not pick the likelier one: the page
carries both, labelled as published, because a reader deciding on this rack
needs to know the listing disagrees with itself.
It is also worth putting beside the maker’s own line that all measurements on
the rack are actual results.
What is genuinely specified
Five by five centimetres and 29.9 kg are both real figures, and together they
make this the most substantial stand in the family.
Fourteen J-hook positions is the joint highest count here. The step is not
published, and without a lowest position the spacing cannot be worked out — a
count alone does not say how fine a ladder is.
The 50 mm storage posts
Published, and it is a fitment figure rather than a convenience. Posts cut for
50 mm will not hold a 30 mm collection, and a buyer with 30 mm plates gets
ballast that cannot be loaded.
Plate storage on a free-standing stand is also what keeps it in place, so the
mismatch would cost more than tidiness.
Left off the listing
No overall height — only the highest hook position, which is a different
figure. No hole diameter, so the attachment question stays open despite the
section being given.
Availability
From 150 € to 190 € across the German, French, Italian and Spanish Amazon stores, on the one reading this page rests on.
The American and British Amazon catalogues list the reference with nobody selling behind it.
These figures are what Keepa returned on the day this page was last written. Stock and prices move without notice.
Prices quoted in this text were read on 20 September 2026. The live price is at the top of the page.
The figures declared, and the gaps beside them
Strengths
Publishes a 5 × 5 cm section and a 29.9 kg mass — the heaviest stand in this family
Fourteen J-hook positions, the joint highest count in this family
Two plate storage posts at 50 mm, published, which is both storage and ballast
Compromises
The listing contradicts itself on load: 800 kg in the title, 200 kg on the J-hooks in the detail
No overall height published, only the highest hook position
No hole diameter
Specifications
Overall height
Not published; the highest J-hook position is given as 137.5 cm
Inside width
Not applicable — two-column stand
Inside depth
Not applicable — two-column stand
Upright section
5 × 5 cm thickened steel plate
Hole spacing
14 J-hook positions and 7 bumper positions
Hole diameter
Not published by the maker
Max total load
The title states up to 800 kg; the detail states the J-hooks carry up to 200 kg. Both are as published
Anchoring
Free-standing; 4 non-slip pads, no fixing pattern published
Amazon reference
B0C27XKJJN (one reference across 6 Amazon marketplaces)
EAN
6975650839871
What buyers ask about this one
Is it 800 kg or 200 kg?
The listing publishes both: 800 kg in the title, and 200 kg for the J-hooks in the specification. This site does not resolve a maker’s contradiction by choosing the likelier figure — the page carries both and says they disagree, because that is what is actually known.
What does the 50 mm on the storage posts mean?
The posts are cut for 50 mm plates. That is a fitment figure and it matters: a 30 mm collection will not sit on them, and the storage is then unusable with the plates in the room.
How high do the hooks go?
The maker publishes 137.5 cm as the highest J-hook position. It is not the overall height of the stand, which is not given, and the two are frequently confused.
Who this one is for
Somebody comparing stands on steel section and mass rather than on a headline
A reference exists on these Amazon stores: France, Germany, Italy, Spain, United Kingdom, United States. Listed is not the same as in stock — availability changes daily.
Details checked on September 20, 2026.
Sources
Specifications: manufacturer sheet and Amazon product page. Prices and availability: Keepa. No product on this site has been physically tested.
A squat stand that publishes a complete dimension block and the size of its adjustment step: seven positions, ten centimetres apart. The step is the figure that decides whether a suitable height exists.
Best for: A low ceiling where 153 cm is the maximum height available
The only stand in this family that publishes its steel section: a 50 mm heavy-load tube frame, with a height range of 106 to 170 cm and a published width of 59 cm.
Best for: Somebody who wants to know what steel the stand is made of
Two separate stands with the highest published figures in this family — 400 kg on the upper rests and 500 kg on the lower safeties — and two different adjustment schemes depending on the variant.
Best for: A room where the stands have to be moved aside between sessions